Time not? wasted

Computer Numerical Control

Time not? wasted

Postby loyd » Thu Jun 27, 2019 11:26 am

They [whoever that was] said that time is not wasted when you learned from the experience.

Untitled.jpg


The thing(s) about the CNC's cutout is that you don't want to be too aggressive with your cut out tool path and you surely want to make sure you have your workpiece firmly secured. This Corian will cut 'almost' like wood but not quite. The only thing left to do after successfully finishing the 3d carving on this figure was to cut the finished piece out of the base material -- less than a minute's work. Unless you ignored the 'thing(s)' mentioned above. :oops:
Loyd -- Administrator
User avatar
loyd
 
Posts: 2445
Joined: Sun Dec 30, 2012 9:56 pm
Location: Manchester, TN

Re: Time not? wasted

Postby southpaw57 » Fri Jun 28, 2019 5:27 am

Basic rule in the CNC world is "raise the tool before moving to a new location to start another operation". In 20 years of CNC experience, when ignoring this rule, success was never the outcome! :geek:
User avatar
southpaw57
 
Posts: 512
Joined: Sun Dec 30, 2012 10:32 pm

Re: Time not? wasted

Postby loyd » Fri Jun 28, 2019 7:02 am

:oops: :oops:
Loyd -- Administrator
User avatar
loyd
 
Posts: 2445
Joined: Sun Dec 30, 2012 9:56 pm
Location: Manchester, TN

Re: Time not? wasted

Postby rgulley » Sat Jun 29, 2019 2:04 pm

CNC gremlins - Grrrr...
User avatar
rgulley
Site Admin
 
Posts: 358
Joined: Sat Dec 29, 2012 11:07 pm


Return to CNC

Who is online

Users browsing this forum: No registered users and 1 guest