Clumsy sprayer

Discussions on finishing products and methods

Clumsy sprayer

Postby loyd » Thu May 02, 2019 3:06 pm

What do you do when you drag the spray gun across wet lacquer as you finish spraying a coat of sanding sealer? I left the imprint of the edge of the bottom of the sprayer can in the finish. I left it that way since I didn't know what to do -- other than to teach my shop ghost a few new words for his vocabulary. Now what? By the way: the sanding sealer is tinted with Solar Lux stain. :x :? :( :cry:
Loyd -- Administrator
User avatar
loyd
 
Posts: 2398
Joined: Sun Dec 30, 2012 9:56 pm
Location: Manchester, TN

Re: Clumsy sprayer

Postby mrl » Thu May 02, 2019 3:48 pm

strip strip and re finish
User avatar
mrl
 
Posts: 101
Joined: Wed Feb 20, 2013 7:49 am

Re: Clumsy sprayer

Postby sid_matheny » Thu May 02, 2019 5:13 pm

What I would do is cry! Sounds like a lot of extra work for you Loyd. Don't know what to say except strip and start over.
Sid Matheny
McMinnville, TN

"To the proud, the applause of the world rings in their ears; to the humble, the applause of heaven warms their hearts."
User avatar
sid_matheny
 
Posts: 1079
Joined: Wed Jan 02, 2013 4:37 pm
Location: McMinnville, TN

Re: Clumsy sprayer

Postby loyd » Thu May 02, 2019 5:28 pm

Mike and Sid have the same advice and it's hard to hear, but sounds like the only solution. :cry:
Loyd -- Administrator
User avatar
loyd
 
Posts: 2398
Joined: Sun Dec 30, 2012 9:56 pm
Location: Manchester, TN

Re: Clumsy sprayer

Postby southpaw57 » Fri May 03, 2019 7:33 am

Practice patience..... Did I mention patience!!!

Got a look this week at the Mexico Beach devastation form hurricane Michael. It is still really bad. :geek:
User avatar
southpaw57
 
Posts: 507
Joined: Sun Dec 30, 2012 10:32 pm

Re: Clumsy sprayer

Postby loyd » Fri May 03, 2019 7:40 am

Did you suggest Patience Southpaw? I think that's what you said.

Too bad about Mexico Beach. Where are you vacationing?
Loyd -- Administrator
User avatar
loyd
 
Posts: 2398
Joined: Sun Dec 30, 2012 9:56 pm
Location: Manchester, TN

Re: Clumsy sprayer

Postby southpaw57 » Fri May 03, 2019 4:37 pm

We are trying Cape San Blas which is around the bay from Mexico Beach and out from Port St. Joe. :geek:
User avatar
southpaw57
 
Posts: 507
Joined: Sun Dec 30, 2012 10:32 pm


Return to Finishing (Products, methods, tools, etc.)

Who is online

Users browsing this forum: No registered users and 2 guests

cron