jointer jig for the table saw

Anything pertaining to the machine itself including accessories, jigs, and fixtures

jointer jig for the table saw

Postby mrl » Tue Feb 05, 2019 8:06 pm

dose any have plans for a jointer jig for the table saw or know where i can get them
User avatar
mrl
 
Posts: 98
Joined: Wed Feb 20, 2013 7:49 am

Re: jointer jig for the table saw

Postby loyd » Tue Feb 05, 2019 9:19 pm

Loyd -- Administrator
User avatar
loyd
 
Posts: 2380
Joined: Sun Dec 30, 2012 9:56 pm
Location: Manchester, TN

Re: jointer jig for the table saw

Postby mrl » Wed Feb 06, 2019 4:57 pm

its close i was thinking of a jig where you mount wort to the jig ant act like a sled
i seen it some where just dont rember
User avatar
mrl
 
Posts: 98
Joined: Wed Feb 20, 2013 7:49 am

Re: jointer jig for the table saw

Postby loyd » Wed Feb 06, 2019 6:25 pm

You may be thinking of the sled that Henry designed years ago for straightening a rough board.
Loyd -- Administrator
User avatar
loyd
 
Posts: 2380
Joined: Sun Dec 30, 2012 9:56 pm
Location: Manchester, TN

Re: jointer jig for the table saw

Postby mrl » Wed Feb 06, 2019 8:29 pm

yes found this one
http://www.woodworkersjournal.com/how-t ... ugh-board/

would like to see the one Henry made
i think there better ones out there will keep looking
User avatar
mrl
 
Posts: 98
Joined: Wed Feb 20, 2013 7:49 am

Re: jointer jig for the table saw

Postby henry » Thu Feb 07, 2019 9:56 am

I not long used a sled for straighting boards. I now tack a straight edge to the board and run the straight edge against the fence. Paneling or 1/4 plywood makes a good straight edge.
User avatar
henry
 
Posts: 485
Joined: Wed Jan 02, 2013 5:04 pm

Re: jointer jig for the table saw

Postby mrl » Fri Feb 08, 2019 8:09 pm

thanks henry good info can i use dubble stick tape
User avatar
mrl
 
Posts: 98
Joined: Wed Feb 20, 2013 7:49 am

Re: jointer jig for the table saw

Postby henry » Fri Feb 08, 2019 11:21 pm

Double sided tape might work better for you if the location of the tack hole would be a concern, like showing up on a piece of furniture. If you are using double sided tape on material with a rough surface I would recommend Gorilla brand tape. It is thicker and sticks better to rough surfaces then thin tape.

Henry
User avatar
henry
 
Posts: 485
Joined: Wed Jan 02, 2013 5:04 pm


Return to Table saw

Who is online

Users browsing this forum: No registered users and 1 guest

cron