The $350 CNC Machine

Computer Numerical Control

The $350 CNC Machine

Postby sid_matheny » Thu Jun 29, 2017 2:19 pm

Sid Matheny
McMinnville, TN

"To the proud, the applause of the world rings in their ears; to the humble, the applause of heaven warms their hearts."
User avatar
sid_matheny
 
Posts: 1035
Joined: Wed Jan 02, 2013 4:37 pm
Location: McMinnville, TN

Re: The $350 CNC Machine

Postby henry » Thu Jun 29, 2017 5:47 pm

Ok you CNC folks ---I have a question . What raised the router bit to make the tabs that held the piece in place. I understand on a three axis CNC how this is done but nothing was said about an axis controlling the router. If you look close the router bit came out to make the tabs.
User avatar
henry
 
Posts: 462
Joined: Wed Jan 02, 2013 5:04 pm

Re: The $350 CNC Machine

Postby sid_matheny » Thu Jun 29, 2017 6:12 pm

henry wrote:Ok you CNC folks ---I have a question . What raised the router bit to make the tabs that held the piece in place. I understand on a three axis CNC how this is done but nothing was said about an axis controlling the router. If you look close the router bit came out to make the tabs.


He is using the Z axis kit that is an extra $60.
Sid Matheny
McMinnville, TN

"To the proud, the applause of the world rings in their ears; to the humble, the applause of heaven warms their hearts."
User avatar
sid_matheny
 
Posts: 1035
Joined: Wed Jan 02, 2013 4:37 pm
Location: McMinnville, TN

Re: The $350 CNC Machine

Postby henry » Thu Jun 29, 2017 7:26 pm

ok Thanks Sid, That cleared that up and thanks for the things you post.
User avatar
henry
 
Posts: 462
Joined: Wed Jan 02, 2013 5:04 pm


Return to CNC

Who is online

Users browsing this forum: No registered users and 2 guests